The phono stage amplifies the very tiny signal (between a few tens of microvolts and a few millivolts) from the phono cartridge to a line-level (about one volt) signal. This line-level signal can then drive a line-stage preamplifier, just as any other source component would.
|
Page 4
( Displaying 10 of 92 Products )
|
|
|
Creek Sequel Mk 3 Adjustable Phono Board
|
|
Creek Audio has always been a fan of the vinyl disc. For those consumers who have an interest in enjoying this alternative source of high quality music, there are few amplifiers available today equipped to deal with this as standard. All Creek integrated amplifiers, from 1993 have been designed to accept plug-in Phono modules, to enable vinyl disc reproduction.
The latest Creek plug-in Phono pre-amp is called Sequel mk3. It is designed to match a wide-range of MM and MC cartridges and can be fitted to the latest integrated amps from Creek, namely the Evolution 50A, Evolution 100A. It can also be fitted to older Creek amps. Please read a definitive list below.
|
|
Arcam rPhono Pre Amplifier
|
|
• Moving coil & Moving magnet support
• Adjustable input impedance 50-550Ω (MC)
• Adjustable input capacitance (MM)
• Rumble filter
• Precision RIAA filter response
• High-end audio circuitry
• Stylish cast aluminium case
The Arcam rSeries products are all about getting the best
sound from any audio device. These products can be used
with any audio system and are a brilliant way to enhance your
audio system.
|
|
|
|
|
|
|
|
|
|
|
Discontinued
|
|
|
|
Graham Slee Accession - MM Phono Preamp With Volume Control
|
|
New Stereo Phono Preamp Stage
•Adjustable and fixed level outputs
•Volume / output level control
•RIAA, NAB (American) and FFRR (British) vinyl record EQ's
•Flat / CA (constant amplitude) alternative EQ
•Mono / stereo switch
•Four cartridge capactive loading options: 100pf; 220pf; 320pf and "out"
If you're serious about vinyl the new Accession is the phono preamp you'll definitely want.
The Accession
|
|
EAT E-Glo S Phono Stage
|
|
EAT E-Glo S Tube Phono Preamplifier
Elegant high-end tube phono pre-amplifier with ultra slim design!
E-glo S – is a hybrid phono preamplifier that utIlizes ECC83 tubes (twin triode) in the first and second gain stages In order to get higher gain and lower noise they used in the first stage a cascode connection of tube with with two paralelly connected low-noise J-FET transistors.
RIAA curve is equalised fully passive and splitted in two steps which allows to achieve perfect impedance matching between the gain stage and equalization block. Phono preamplifier doesn’t have any global feedback. It has a massive aluminium chassis, large possibility of adjusting the impedance, capacity and gain. It has subsonic filter with mild effect which doesn’t affect audible frequencies in unpleasant way.
A very important part is the advanced power supply that uses anode voltage regulation and a well filtrated voltage. Filtration is in three steps, this result is a perfect S/N ratio and undisturbed musical experience.
|
|
|
|
|
|
|
|
|
|
|
£ 2,598.00
* |
|
|
| * Only available for purchase in-store |
|
Trichord In-Line AC Toroidal Power Supply
|
|
Toroidal AC Power Supply
This is the basic power supply and is provided as a low cost introduction.
Performance level will be more than adequate for many users, but you can upgrade at any time to the ‘Dino+’ power supply, or for ultimate sonic performance – the ‘Never Connected Dino+’ PSU.
The ABS molded housing of the Toroidal power supply contains an in-line low noise 40VA transformer. AC current is fed to the Dino where it is rectified to DC and regulated with two high performance, wide bandwidth Super Regulators.
|
|
Trichord High Performance DC Power Interconnect Lead
|
|
The High Performance Power Lead connects the Diablo Phono Stage to the ‘Never Connected’ power supply. It is designed to significantly improve sound quality over the standard DC power interconnect lead.
Just as signal interconnect leads make a sonic difference to the performance of a system, then so do mains leads and any other lead connecting two pieces of equipment.
Here is an excerpt from a Hi Fi Choice Review:
|
|
Luxman EQ-500 (EQ500) Phono Stage
|
|
Luxman’s last top of the line phono stage, the E-1 (solid state) was released in 2001 and was only recently discontinued. Since the introduction of the award winning PD-171 in 2011 and the subsequent PD-171A and PD-171AL turntables, Luxman’s engineers were eager to return to the drawing board and deliver a fresh design using all of the best parts at their disposal for a complimentary phono stage.
Given
|
|
Audio Research Reference Phono 3
|
|
REFERENCE PHONO 3
VACUUM TUBE PHONO PREAMPLIFIER
When Audio Research was founded in 1970, analog vinyl playback was the de facto music source of the time. Audio Research has either incorporated or built stand-alone phono stages since the very beginning, and has continuously provided phono preamplification, even during the height of digital music. The Reference Phono 3 is the next advancement of analog playback.
|
|
|
|
|
|
|
|
|
|
|
£ 14,998.00
* |
|
|
| * Only available for purchase in-store |
|
EAT E-Glo Phono Stage
|
|
EAT E-GLO phono stage
Prague, 10 May 2013: Completing its analogue ‘front-end’, E.A.T. proudly announces the definitive phono stage to accept the signals from its range of turntables, tone-arms and Yosegi cartridges. The E-GLO looks and performs like no other, a design so clever and attractive that owners will want to give it pride-of-place in their sound systems. After all, it complements the stunning Forté, Forté S and E-Flat turntables!
|
|
|
|
|
|
|
|
|
|
|
£ 6,298.00
* |
|
|
|
|
|
£ 6,298.00
* |
|
|
| * Only available for purchase in-store |
|
Clearaudio Smart Phono V2
|
|
A light 620-gram phonostage that seduced the worldwide audio press. The only thing that is 'entry level' about this product is its price.
A minimalist aluminium housing that contains one of the best sounding phonostages in its market. Up to 54 decibels gain at one kilohertz and an extremely linear frequency response deliver unprecedented quality at this price point. For MM and MC cartridges there are two separate circuit designs using SMD technology, which are selected by a slide switch on the underside.
|
|
Page 4
( Displaying 10 of 92 Products )
|
|
Search for products that may contain the words:
within
using