WLED30CV4
The WLED30CV4 is a wired 4 channel,
30W/Channel (RGB+White) constant voltage dimming
LED driver, suitable for ceiling or cupboard mounting
Designed for use with 3 or 4 channel constant voltage LED fittings and 3
or 4 channel LED tape light with common +ve and individual -ve
connections. Maximum wattage of 120w when used as 4 channel or
90w with 3 channel for 12V d.c. fittings or 240w (60w per channel) for
24V d.c. fittings.
Requires a suitable external d.c. power supply (normally the power
supply that would be supplied with the fitting for a non-dimming
application).
Programmed using the RASOFT PC software suite, the unit stores the
house, room and channel address plus 16 preset scene levels in non
volatile memory.
Connection to the Rakom wired network can be via the RJ11 lead,
plugging into a RAKLink or RAKStar unit. Alternatively a WPCON or
WPCONC unit can be used as a remote plug in connection point.
Installing a Bridge or WRB100 as part of the wired system will allow the
WLED30CV4 to receive commands from wireless devices as part of a
“combined” or “hybrid” system.
For more information on dimming LEDs refer to Rako's application sheet
'Controlling LED Lighting With Rako Dimmers and Modules'.
A compact 4 channel 30W per
channel, constant voltage LED
dimmer with in-built wired
receiver and Rako processor for
control of 4 channel constant
voltage LED fittings.
When used with RGBW fittings
each colour is allocated a
channel and can be individually
adjusted allowing complete
colour mixing. Simple colour
cycling is started/stopped using
the fade commands
(raise/lower).
Controlled from any Rako
Wired device, e.g. WCM,
WAPIR or from wireless devices
via a WA/WTC-Bridge or a
WRB100.
Technical Specifications:-
Dimensions: 172x46x40mm
Input Supply: 12V/24V DC power supply depending on load 12-18V DC supply from Rako wired network for control
Housing: UL V0 ABS
Weight: 175g
Climate Range: Temperature +2C to +40C, Humidity +5% - 90% non condensing
Connections: 2 way screw terminals for 12-24v DC supply. 6 way screw terminals for load connections
Protection: Reverse polarity input protection. Output current limit protection
Load Types: Four channel constant voltage LED fittings and tape
Min/max loads:
1W per channel Min
12V DC 3 channel @ 90W Max
12V DC 4 channel @ 120W Max
24V DC 3 channel @ 180W Max
24V DC 4 channel @ 240W Max
Terminal sizes: 4 mm2
Standards: Emissions - EN61000-6-3 : 2007 / Immunity - EN61000-6-1 : 2007
Communication: Rakom wired network
Memory: Flash memory (non volatile)